Description
The “N1” is a Urethane/Acrylic co-polymeric emulsion hybrid system designed for high performance uses where hardness, flexibility, chemical resistance and abrasion resistance is required. This product can be used on interior wood, Fiberglass, as well as many other interior and exterior surfaces such as vinyl, plastics, primed metal, interior floor finishes and brushing enamels.
Features:
• Non Toxic
• Easy to Apply
• UV Resistant?
• Abrasion resistant
• Chemical resistant
• Impact resistant
• Flexible
• Colorfast
Available in Quarts, gallons or 5 gallon pails.
We can mix and match almost any color you need. Special color matching is available in quarts, gallons, 5 gallon pails and 50 gallon drums. If the color you want is not on the RAL color chart you can send us a sample of the color and we will match it for you.
We can mix and match almost any color you need. Special color matching is available in quarts, gallons, 5 gallon pails and 50 gallon drums. If the color you want is not on the RAL color chart you can send us a sample of the color and we will match it for you.
Please specify your desired RAL color number in the Comment/Delivery section when you check out or indicate if you are sending a sample.
Below are our 14 Standard colours
FULL RAL colour chart
Application instructions for A1-Kolor
Clean surface well with “Parakleen” and let dry.
Spray “N1″ from about 8 to 10 inches away, approximately 5 to 15 minutes apart (2 to 3 coats depending in film thickness of 1st and 2nd coat.)
Let dry for 24 hours for proper cure.
Ready to Use: “N1” is available in Matt, satin semi-gloss and Gloss. Two to 3 coats recommended.
Typical Setup: Air dry
Airless Spray:
Fluid Pressure?1400 – 2400 psi
Tip Size: .08-.015
Air Assisted Airless:
Air Pressure: 10-20 psi
Fluid Pressure: 500-800 psi
Tip Size: .008-.015
HVLP- Pressure Feed:
Air Inlet Pressure: 20-30 psi
Fluid Pressure: 5-10 psi
Tip Size: 1.4-1.8
Coming Soon!!!
Coming Soon!!!